PLA+ 1.75mm filament
eSun's new improved version of PLA, the easy to use and low cost 3D printing material.
Great looking prints with no hassle. 10 times tougher than standard PLA and with better layer adhesion.
Made from corn starch, it is organic and non-toxic.
Recommended printing temperature 205-225°C.
For bed adhesion, a heated bed is advised but it is not required. Bed temperature 60-80 °C or no heat.
PLA+ is great for prototyping.
eSun is recognised as one of the best manufacturers of filament from China.
We stock eSun 1.75mm PLA+ filament in 0.5 kg and 1kg spools in our warehouse in Perth in the following colours
- Peak Green
- Pine Green
- Light Grey
- Light Blue
Factory quoted physical properties of eSun PLA+ filament.
- Density 1240 kg/m3
- Approximate length of 1.75mm filament per 1kg roll 340 to 345 metres
- Distortion temperature 52°C
- Melt flow index 2 @ 190°C
- Tensile strength 60 MPa
- Elongation at break 29%
- Bending strength 87 Mpa
- Flexural modulus 3642 Mpa
- Impact strength 7 kJ/m2
|Filament Spool Size||N/A|